







Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Chain Link Fence in Westview, FL: What It Costs and How Long It Takes
A chain link fence on a standard Westview lot runs $3500 – $9000, and most residential jobs are finished in two to four working days once the permit clears. That range covers a typical 4-foot or 6-foot galvanized or vinyl-coated run with posts set in concrete, gates hung, and the site cleaned up. Call (833) 716-6251 and we’ll walk your property line and put an exact number in writing.
How We Build a Chain Link Fence in Westview, Start to Finish

There’s a rhythm to this work, and knowing it before day one saves arguments later. Here’s the sequence.
Stage 1: Site walk and line layout (about 45 minutes)
We mark the property corners and walk the proposed line with you so there’s no dispute about where the fence actually goes. This is where you decide gate width and swing direction, and whether the run follows the lot line tight or steps around an existing concrete pad. If a survey is missing, we’ll flag it now rather than after the holes are dug.
Stage 2: Utility locate and permit filing (1 – 2 weeks on the calendar)
Florida law requires underground utilities be marked before you dig, so we call in the locates and wait for clearance. In Westview, where a lot may sit between two new duplex builds, we also confirm the fence line doesn’t land on a neighbor’s recorded improvement. Permit filing happens in this window. You decide here whether to pull a permit at all, and we tell you plainly what the jurisdiction expects.
Stage 3: Removal and prep (half a day to a full day)
If there’s an old rusted run, we pull posts, cut the fabric down, and haul it off. Concrete footings for gate posts get broken out with a breaker rather than hammered by hand. On a tight Westview block, debris goes into one staging spot near the street so we’re not blocking a driveway for three days.
Stage 4: Setting posts and stretching fabric (one to two days)
Posts go in at 8-foot spacing, set in concrete and left to cure before the top rail and tension wire go on. Fabric gets stretched with a come-along until it’s tight enough to resist a shoulder push, then tied off at every post. Gate frames are assembled square and hung with hinges that can be adjusted later without pulling the post. You walk it with us before we leave.
Stage 5: Final walkthrough and warranty sign-off (about 30 minutes)
We check every tie, every post cap, and the gate latch. Any dip or sag gets corrected on the spot. You get the written guarantee paperwork at the end, not three weeks later in an email nobody opens.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
The Chain Link Options You’ll Actually Choose Between
Chain link isn’t one product. Most of the decisions come down to coating, gauge, and height, and each moves the price.
- Galvanized vs. vinyl-coated: Bare galvanized is the cheapest and holds up fine, but in South Florida’s salt-heavy air and summer sun it dulls and can spot with rust faster. Vinyl-coated in black or green costs a bit more up front and looks cleaner against a Miami-Dade block wall. Most Westview homeowners pick coated for the front run and galvanized for the back.
- Wire gauge: 11.5-gauge is the residential standard. 9-gauge is heavier and resists deformation from a dog or a mower, but it adds cost per linear foot. If you have large dogs or a corner lot, the heavier gauge earns its keep.
- Height: 4-foot is the common choice for a boundary; 6-foot gives better screening and is what most people want for a backyard. Above 6 feet usually triggers additional permitting questions, so plan the height before you file.
- Post and rail gauge: Schedule 20 pipe is the standard residential post. Schedule 40 is thicker and the better call if you’re fencing a run that takes wind load or a gate that gets used daily.
- Gates: A standard walk gate is straightforward. A double drive gate needs heavier posts and a proper drop rod, and it adds to the cost. Decide the gate count early because posts get set around it.
We finish most Westview installations with a galvanized top rail and tension wire, which keeps the fabric from bowing at the bottom over time.
What a Chain Link Fence Costs in Westview, FL

Plan on $3500 – $9000 for a residential chain link fence here. The low end covers a modest backyard run in galvanized; the high end covers a larger perimeter with coated fabric, a drive gate, and an older fence removed first.
Five things move that number:
- Linear footage. This is the biggest driver. A small yard might be 120 feet; a corner lot can push past 300.
- Existing fence removal. Pulling old posts and footings adds labor and disposal. Rusted posts set in concrete take longer than clean ones.
- Coating and gauge. Vinyl-coated 9-gauge fabric runs noticeably higher than bare 11.5-gauge.
- Gate count and size. Every gate adds a framed panel, hinges, a latch, and heavier posts.
- Terrain and obstructions. A run that crosses a concrete pad, a tree root zone, or a buried sprinkler line takes more prep. On Westview’s older lots, we routinely find unrecorded improvements that have to be worked around.
A written estimate from us lists footage, gauge, coating, gate count, removal, and permit line separately, so you can see exactly what’s in the number. It doesn’t cover landscaping repair if we have to cut through a hedge, and it doesn’t cover a survey if one is required.
See the difference
Before
After
Before
After
Before
AfterWhat Westview Homes Specifically Do to This Job
Westview (ZIP 33167) is a working-class, historically Black community in Miami-Dade’s northwest corridor, and that shapes the work in ways a suburban job doesn’t. The housing stock is mostly 1950s through 1970s concrete-block homes, and many sit on blocks that now have new duplexes and multi-family infill going up beside them. On a lot like that, the fence line often runs between an aging owner-occupied house and a newer build, and we have to confirm where the recorded property line actually sits before a single post goes in. We’ve seen plenty of cases where an addition was built without records, and that means the fence can’t just follow a wall that’s already there.
The climate adds its own pressure. South Florida’s sun and summer thunderstorms beat on chain link, and hurricane season from June through November makes wind-rated post spacing and proper footing depth worth doing right the first time. If your fence is part of a full Fence Installation in Westview plan that includes other sections, we’ll sequence it so the lines stay consistent. Homeowners working through a larger property project often pair this with ADU Site Prep & Utilities in Westview or with Door Installation in Westview, and we’ll coordinate the timing so crews aren’t tripping over each other. Our Fence Installation service covers the full scope if you want to see the broader picture, and we work across Westview and the surrounding blocks.
Serving Westview, FL – Our Local Coverage Area
We serve Westview and nearby communities. Use the map below to see the area we cover. If you’re nearby, we can almost certainly help.
Frequently Asked – Chain Link Fence in Westview

Most residential jobs take two to four working days on site, plus the one to two weeks it takes to clear utility locates and file the permit. The on-site work splits into about a day of removal and prep, one to two days setting posts and stretching fabric, and a short walkthrough. Call (833) 716-6251 for a timeline specific to your lot.
Miami-Dade generally requires a permit for a new fence, and the height and setback rules depend on where your lot sits. We’ll tell you exactly what your property needs before any work starts and handle the filing. Call us for a straight answer on your address.
Yes, in almost every case. Chain link uses small concrete footings at each post, so we’re not excavating a trench or moving plumbing or electrical. We do call in utility locates first to avoid a buried line. If a run crosses a concrete pad or a sprinkler line, we’ll flag it at the site walk.
Residential chain link in Westview runs $3500 – $9000, with the final number driven by footage, coating and gauge, gate count, and whether an old fence has to come out. Estimates are free and the number you see is the number you pay. Call (833) 716-6251 for an exact quote.
Every chain link fence we install is covered by our 730-Day Done Right Promise: if it’s not done right, we make it right. That’s one of the longest workmanship guarantees in residential construction. Call (833) 716-6251 to schedule a walkthrough.
Get a Free Chain Link Fence Estimate in Westview
If you’re ready to put up a chain link fence in Westview, call (833) 716-6251 for a free on-site estimate. We’ll walk the line, check for underground utilities, and hand you a written, line-item number covering footage, gauge, gates, removal, and permit. We’ll also explain financing options, including 0% for 18 months, and the $1,000 off projects over $10,000 if your fence is part of a bigger property project. No surprises, no pressure.
Written by the team at Groundwork Construction Co.












